Hello,
I purchased a better power supply for my GIGABYTE GA-965P-DQ6 that is
running an XE 6800.
The new power supplly has a 4+4 pin +12V power connector and I was
wondering how I would connect the cable to my GIGABYTE GA-965P-DQ6
motherboard. That is, would I connect one four pin cable as with my
current power supply or would I remove the cap from GA-965P-DQ6 ATX
power connector on the motherboard and use both 4 pin connectors. The
new power cable will pop apart at the end if needed.
The manual describes a 2x2 and a 2x4 power supply but I do not
understand the differences; the power supply is a Thermaltake.
Thank you
|
Linear Mode
