68HC505J1A int pin edge/level sensitivity for BIH & BIL too?

09-10-2006, 07:17 AM

The bit in the MOR that controls the int pin for edge or edge & level
sensitivity, does that apply only for interrupts, or also for BIH & BIL
instructions?

09-10-2006, 12:35 PM

IRQE does not affect the opcodes, they read the pin direct.
The schematic is on page 87 of the databook/sheet ( "figure 1" ).

MfG JRD

09-10-2006, 11:25 PM

Got it. Thanks, Rafael.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Touchpad sensitivity	Nathan Gutman	Gateway	6	11-23-2005 01:53 AM
Touchpad sensitivity	Nathan Gutman	Laptops	3	11-20-2005 09:47 PM
Presario 2700 touchpad sensitivity	chulavista@cheerful.com	Laptops	0	02-03-2005 08:17 PM
A7N8X Motherboard Low Temperature Sensitivity, CMOS Checksum Error	kony	Asus	0	10-10-2004 05:32 AM
Inspiron 8600 Touchpad Sensitivity	Larz F. Kremer	Dell	0	09-16-2004 05:54 PM