I installed the new board (Athlon 2600+ 333 and 256 megs PC2700) and ran
into troubles while installing the new OS on the new WD hard drive. It
gets to the point where it says "Starting Windows" and then it either
freezes up or I get one of numerous error messages, like a page fault
error, etc. I also tried formatting the HD and installing Windows 98SE,
but it usually just reboots at some point during the install. I also
tried moving the ram to a different slot and I went and bought a new
stick of ram and tried that too, no good....
Anybody have any ideas????
John
--
++++++++++++++++++
http://www.lost-ark.com/
http://www.needgod.com/
Similar Threads
Linear Mode
