Dagger wrote:
> A question about a P4C800 Delux
>
> P4 intel @ 3gig
>
> This board has 4 DIMM Slots PC3200
> BIOS says its operating dual channel mode @ 320mhz
>
> Shouldbt it be 400mhz
>
> Memory Modules c,d
>
> 2558 Megabytes Installed Memory
>
> Slot 'DIMM0' has 1024 MB (serial number SerNum0)
> Slot 'DIMM1' has 512 MB
> Slot 'DIMM2' has 1024 MB
> Slot 'DIMM3' has 512 MB
>
> My question is why isnt all the memory being shown?
>
> Shouldnt it be 3072 ?
>
> Just looking for an explination and a way to optimize performance if
> anyone knows of one
> Thank in advance
Are the two pairs of memory the same manufacturer?
If you have the manual, check page 2-11. There is a Qualified Vendor
List. If you use other brand or size modules, you may experience
problems.
The note below Table 2 says that when using 800 MHz CPU FSB speed,
PC2700 DIMMs may run at 320 MHz (not 333 MHz) due to chipset limitation.
Look into the BIOS and make sure the CPU and memory buss speeds are
correct. Set the memory CAS, etc. timings manually.
|
Similar Threads
Linear Mode
