On Tue, 20 Oct 2009 13:01:35 +0200, Hueyduck <sea->
wrote:
>Hi everyone,
>
>I'm currently tracking the reason for memory errors in my system (1
>error after 1500% testing by memtest under windows).
>
>This set of memory sticks is installed:
>F2-8500CL5D-GGBPK
>G.skill DDR2-1066 PC2-8500 2048 x 2 CL5-5-5- 15 2.0-2.1V
>
>Under the BIOS "PC Helth Status", I read
>DDR2/DDR3 Voltage 2.032V => this is normal
>
>In the BIOS, I go to "MB Intelligent tweaker"
>DRAM Timing is on auto and gives 5-5-5-15==> that's normal.
>
>*BUT*
>at the end of the MB intellibngent tweker settings, there are the:
>"system voltage control" wich are set on Auto:
>
>the DDR/DDR3 OverVoltage Control is set to +0.2V
>With a big fat red comment on the right pannel saying "Warning: Voltages
>may be raised for optimizing overclock".
>
>I just want my system to ba stable, so I will go unde r the manual
>volatge control and set the DDR2 overvoltage control to "normal".
>
>And then I have 2 questions:
>
>Is it possible that this setting is the only cause of my problem (memory
>errors)?
>
>How can a default setting be unsecure?
>
>Anyway, I will lauch a new test and let you know how it went. Might be
>useful for someone else.
>
Your dilemma is caused by that your Gskill needs 2.0-2.1 volt. Nominal
standard voltage for DDR2 is just 1.8 volt. But many brands require
more than 1.8, per example corsair. Kingston value ram can run with
1.8 volt. If I were you I would give the ram no less than 2.1 volt.
An overvoltage of 0.1 volt is a very modest overclocking, and you
reach that on 2.2 in your case.
If you insist on 1.93 volt you might have to lower the timings to
something slower than 5-5-5-15, or lower the speed to below 1066 (266
x 4), per example 800.
CPU-z can tell something about how ram runs. Download cpu-z.
You are lucky that your motherboard can find out to boot with your
ram. In the beginning of the DDR2 era this was a problem. They could
only boot default with 1.8, and how do you increase voltage without a
bios to set it in.
I have the very same motherboard. I use muskin ram, and runs 800. I
never loved the motherboard, since it is not willing to run with 4
sticks of these. So I am stucked at 2x2 Gb. It reboots continuously in
a cycle with 4 sticks (bios trying to find a compromise).
I have tried also asus and msi P35 chipset variants, and they wouldn't
either.
It is probably a P35 limitation. But with AMD I have no problem: 4x2
Gb.
best regards
John
|
Similar Threads
Linear Mode
