"Ikaros" <> wrote in message
news:f177f0ab-2473-4e89-b79a-...
On Oct 13, 9:06 pm, "SC Tom" <s...@tom.net> wrote:
> "Ikaros" <snmavro...@gmail.com> wrote in message
>
> news:cbb23e91-3772-4ae9-9c1f-...
<Snipped for clarity>
Well here is a picture of the inside of my Gateway FX530 computer:
http://www.evga.com/community/ModsRi...2_10609_05.jpg
The blue Antec slot cooler pulls cool air in from the outside and is
blowing onto the bottom of the card circuit board. Technically it is
supposed to be positioned over the top of the GPU fan opening but
there is no way to do it in this case configuration. But it does still
helps to lower the GPU temps by 10 degrees centigrade than without it.
You can see the silver CPU heat sink invades the GPU cooler housing,
so much so that EVGA must have partnered with Gateway to make then a
specially molded housing that includes a notched out area for it. The
EVGA part number is 768-P2-N833-BR (EVGA site photo -
http://www.evga.com/products/images/...768-P2-N833-BR)
and even includes an EVGA/Gateway logo on the cooler.
This is why I'll probably never be able to replace the card with
something else unless I know the exact clearance dimensions first or
replace that block of a CPU heatsink!
Steve
I added this hdd cooler on my computer that I bought from my local computer
shop
http://www.amazon.com/gp/product/B000HVHCKS I didn't attached my
hard drive to it. I came up with an idea to put it into an unused slot to
draw air into the front of the computer and the slot cooler in the rear
would draw air out.increasing air flow. Would it be possible to add a
exhaust fan on the side of your case to draw air out while a hdd cooler fans
and your slot cooler is pulling air in?
Good Luck,
Ron