I've been using version F13 BIOS and have the two hard disk controllers
set to "AHCI" in the 'Integrated Peripherals' BIOS setup screen. The
'AHCI' setting seems to allow faster disk transfers, but this could be
my imagination.
I updated to the 25 June 2009 F14 BIOS and the boot hangs while
detecting drives at the 'ONBOARD SATA' (Gigabyte Controller) screen. I
couldn't get to the BIOS setup to restore defaults as the Gigabyte
controller screen appears before the BIOS setup.
So, I reset the CMOS using the jumper. Using default settings for
everything else it seems that the combination of the F14 BIOS and the
'AHCI' setting for the 'ONBOARD SATA' controllor (the one towards the
bottom of the 'Integrated Pheripherals' screen) means the board locks up
while detecting the drives. The F14 BIOS seems to work OK if I turn the
"ONBOARD SATA' setting back to the default 'IDE'.
I reinstalled the F13 BIOS and everything works in 'AHCI' mode as before.
So, if you have your "ONBOARD SATA' set to 'AHCI' I suggest you
don't install the F14 BIOS.
I'd be pleased to hear from anyone who has successfully installed the
F14 BIOS and is using the 'AHCI' mode for the "ONBOARD SATA" contoller.
http://www.giga-byte.com.tw/Support/...ProductID=2457
Similar Threads
Linear Mode
