Memory speed probs with SN41G2 v 2

when I got the Xpc I used the on Board and read that the memory would
only run at 333 max. I now have a Ati 9800 Pro and I set the memory to
Auto in the BIOS and it showed as 400 in the POST screen but after a
few minutes it gets BSOD or shuts down.

As soon as I drop the memory speed back to 333 its stable again

Using Crucial PC3700 Micron Tech. 16VDDT6464AG-40BCB

2 x 512Mb


Memory Module Properties
Module Name Micron Tech. 16VDDT6464AG-40BCB
Serial Number 1668154023
Module Size 512 MB (2 rows, 4 banks)
Module Type Unbuffered
Memory Type DDR SDRAM
Memory Speed PC3200 (200 MHz)
Module Width 64 bit
Module Voltage SSTL 2.5
Error Detection Method None
Refresh Rate Reduced (7.8 us), Self-Refresh
Highest CAS Latency 3.0 (5.0 ns @ 200 MHz)
2nd Highest CAS Latency 2.5 (6.0 ns @ 166 MHz)

Memory Module Features
Early RAS# Precharge Not Supported
Auto-Precharge Not Supported
Precharge All Not Supported
Write1/Read Burst Not Supported
Buffered Address/Control Inputs Not Supported
Registered Address/Control Inputs Not Supported
On-Card PLL (Clock) Not Supported
Buffered DQMB Inputs Not Supported
Registered DQMB Inputs Not Supported
Differential Clock Input Supported
Redundant Row Address Not Supported


what settings do I need to get it running at 400 without crashing ?

Thanks

--
<--ROT13 it
Spam Trap in Header

Child Birth is hereditary,
If your parents didn't have any children
Then the chances are you wont.


http://borg.no-ip.com