p4 overclocking error

Well, i just installed a water-cooling system to start overclocking -
fooled around with the fsb speed in bios and rebooted the computer.
Everything goes well until the computer tries to load windows. I get
an error saying

"Windows could not start because of an error in the software
Please report this problem as: load needed DLLs for kernel.
Please contact your support person to report this problem."

I know is not a problem from tryin to increase the fsb too much cuz I
tried from 133.3 x 17(original speed) to 133.6 x 17 and i still get
the same error msg. Do i need to do something in the registry or
what?

Did you overclock your pci bus? It should only run at 33Mhz. Anything over
33 will give you unwanted OS errors.


"-=adrenaline" <> wrote in message
news: om...
> Well, i just installed a water-cooling system to start overclocking -
> fooled around with the fsb speed in bios and rebooted the computer.
> Everything goes well until the computer tries to load windows. I get
> an error saying
>
> "Windows could not start because of an error in the software
> Please report this problem as: load needed DLLs for kernel.
> Please contact your support person to report this problem."
>
> I know is not a problem from tryin to increase the fsb too much cuz I
> tried from 133.3 x 17(original speed) to 133.6 x 17 and i still get
> the same error msg. Do i need to do something in the registry or
> what?