On Thu, 29 Jan 2004 03:10:33 GMT, "Milhouse Van Houten"
<> wrote:
>Just a final P.S. to this thread. According to Intel, the P12 BIOS was
>pulled for the following minor reason:
>
>
>"The BIOS version P12 was removed from the website because under certain
>configurations the Intel(R) Active Monitor was not responding properly."
>
>I would guess that the following item in the P13 rev notes corresponds to
>that problem, though I notice that Active Monitor itself was updated to
>v1.20 a few days ago:
>
>"Fixed an interoperability issue with the Intel SMBUS Driver."
>
Hey all,
Found this thread regarding the new BIOS for this board and thought
this might be a good place to ask a question. I've just installed a
new Retail D865GBFL board with a 2.4C P4 and 512MB Crucial DDR400 in
Dual Channel Mode. It had the P10 BIOS installed, so I flashed it with
the just released P13.
When booting it gets to where it detects the processor, memory, hard
drive and two CDRW drives and then it halts and says press F4 to
continue. I do and it boots XP Pro SP1 with no problems and everything
works as advertised.
My question is, is it supposed to halt after detecting all the
hardware before it loads XP?? I've never seen a board do that before.
I've looked at all the settings in the BIOS and don't see anything
unusual. Any ideas here?? Thanks for any help or suggestions.
|
Similar Threads
Linear Mode
