On Fri, 11 May 2007 10:48:43 -0500, Journey <> wrote:
>On Fri, 11 May 2007 07:39:02 -0500, RnR wrote:
>
>>On Fri, 11 May 2007 01:56:44 -0500, Journey <> wrote:
>>
>>>First I want to say that my memory is bad and I don't know if I
>>>disabled my card reader. I did install a 3rd drive in my XPS 410, and
>>>maybe that is related to what I am posting about.
>>>
>>>My card reader drives do not show up, and I want to enbale the SD
>>>drive. I went into the System | Device Manager, and could not see the
>>>drives to enable them. I looked under the disk drive category where I
>>>thought I saw them before, but they aren't there.
>>>
>>>I went through the Add New Hardware wizard, and that didn't find them.
>>>
>>>I think the next step I will try is to open the case, "unplug" the
>>>card reader drive, boot up the computer, shut down the computer, plug
>>>the card reader drive back in, and start the computer up, hoping that
>>>then it will find it as new hardware. Is that a good approach?
>>>
>>>If anyone knows what the problem is your input is appreciated. If I
>>>can't figure it out I'll just use a USB card reader. Thanks.
>>
>>
>>This may sound stupid but I thought you disabled or removed your card
>>reader from some earlier post??? If I'm wrong just ignor this.
>>
>>Assuming I'm wrong above, my first instinct would be that the drivers
>>are missing so I'd probably try to reinstall them. If that doesn't
>>help, then I'd try your approach (I'm lazy and don't like to open the
>>case unless necessary).
>
>The earlier post probably discussed that I am going to add a 4th drive
>which would be where the card reader is. I haven't done that yet
>though. I am waiting for a good Seagate or WD 500G in the low $100
>price range. I have seen Maxtors at $109 but want a different brand.
>
>Until your post it didn't occur to me to go find the drivers off the
>Dell site and install them. I thought that I would have seen them in
>the device manager, and when I did the add hardware check it didn't
>find any.
>
>So, I am going to do what you said first, and if that doesn't work
>then I am going to do the boot process I wrote above. If that doesn't
>work then I'll use a USB card reader and forget about trying to get
>the one built in to the computer to work. Thanks!
Don't give up Journey. I'm sure one of us will solve your problem !!
|