A1000 controller

I recently had to replace a failed controller in an A1000, however,
rm6 or Solaris is unable to see the original RAID 5 LUN. I am unable
to find a procedure in the RM docs that addresses this scenario. Can
anyone offer any suggestions or point me to the procedure to restore
the data.

Thanks so much!
-Terry

On Thu, 26 Jun 2003, Terry wrote:

> I recently had to replace a failed controller in an A1000, however,
> rm6 or Solaris is unable to see the original RAID 5 LUN. I am unable
> to find a procedure in the RM docs that addresses this scenario. Can
> anyone offer any suggestions or point me to the procedure to restore
> the data.
>
> Thanks so much!
> -Terry

Your not supposed to have to do anything, after a replacement, it should
read its information from the disks and work again, the controller would
read its info from some selected disks and kick up.


i.e.

* shut down OS
* shut down A1000
* replace controlelrboard
* power up A1000
* start OS

The OS is just to let the RM6 relock the configuration data and
is not really a part of the repair routine.

Is this what you have done?

/Johan A