[A7V8X-X] Windows XP installation with RocketRaid 404 RAID controller

Discussion in 'Asus' started by Stanley Krute, Jul 7, 2003.

  1. Howdy

    Built a system this weekend with

    o- Asus A7V8X-X, board rev. 1.01, BIOS 1003 (later updated to 1005)
    o- Highpoint RocketRaid 404 RAID controller, BIOS and driver set 302
    o- AMD Athlon 2400+ boxed retail CPU
    o- Windows XP Home with Service Pack 1
    o- Corsair 512 MB VS-series PC-2100 memory modules
    o- Western Digital 120-GB 7200-RPM 8-MB-cache hard drive

    Executive summary:

    I was unable to use the RocketRaid 404 during
    XP installation. Couldn't get past Go.

    I had no problems using it AFTER XP installation.

    Some details:

    To use the RR 404 during setup, you press F6 during the
    very beginning of the XP setup process, to tell
    XP setup you've got some special
    SCSI-ish drivers to load.

    There was no problem subsequently loading the drivers.

    However:

    After the RR drivers are picked up, and Windows XP
    setup loads a whole bunch of other drivers, it gets to its
    main initial setup screen, where you get to press Enter
    to install Windows XP, or F3 to bail.

    Pressing Enter at this point, when using the RR404,
    caused an immediate crash. Sometimes
    the system would just reboot, sometimes it would
    blue-screen with a page fault.

    It did this whether I had two or three of the Corsair
    512 MB memory modules installed.

    So:

    I hooked up the hard drive to the board's IDE controller.

    Setup went fine.

    After setup, I shut down XP, installed the RR404 board (I'd
    removed it during setup), booted up, XP recognized
    the new hardware, I fed it the drivers, rebooted,
    shut down, hooked the drive up to the RR, rebooted,
    and all was then just fine. Slick and cool how XP
    just deals with a drive controller change, unlike
    its NT forebears.

    That's it. Just wanted to get this info out there so others
    can benefit from my journey.

    Stan
     
    Stanley Krute, Jul 7, 2003
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.