1. This forum section is a read-only archive which contains old newsgroup posts. If you wish to post a query, please do so in one of our main forum sections (here). This way you will get a faster, better response from the members on Motherboard Point.

Arm7 or PC104 or something else

Discussion in 'Embedded' started by Robert Gush, Sep 24, 2004.

  1. Robert Gush

    Robert Gush Guest


    We have to tackle a new job that is going to use VOIP. I am wondering
    whether the ARM7 series from Philips would be up to the job or if it
    would be better to go the PC-104 route.

    The plus points on a PC-104 system are:

    a) Ethernet interface
    b) OS such as linux available
    c) Mass storage (Comapct Flash etc) available

    The plus points for the ARM:
    a) A lot of fun writing the code...

    Can you give any further insight please?


    Robert Gush, Sep 24, 2004
    1. Advertisements

  2. We have to tackle a new job that is going to use VOIP. I am wondering
    you could check EP9301 from Cirrus, it has build in Ethernet and it's
    more capable than LPC, the development board comes with prebuild Linux
    and WinCE on CD

    Best regards
    PCB prototypes for $26 at http://run.to/pcb
    PCB any volume assembly (http://www.olimex.com/pcb/protoa.html)
    Development boards for ARM, AVR, PIC, and MSP430
    Tsvetan Usunov, Sep 25, 2004
    1. Advertisements

  3. Have a look at Freescale 56800 series.
    These processors called hybrid DSP.
    A lot of code included in their free compiler with IDE and code wizard.


    www.elitel.pl - control systems design and development
    G.shdsl Focus 4.6mbps modems:
    Progressive Jackpot systems for casinos:
    Piotr Stawicki, Sep 26, 2004
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.