asus p2b pentium3

Discussion in 'Asus' started by Mimmo, Mar 25, 2005.

  1. Mimmo

    Mimmo Guest

    I have an asus p2b rev. 1012, ms6095 master adapter slot 1 fc pga , a
    pentium III fc pga 700 mhz, 1,7 volt, 100 mhz. Could you help me how to
    set the jumpers on the adapter so that it will boot? Thanx a lot. Bye,
    Mimmo
     
    Mimmo, Mar 25, 2005
    #1
    1. Advertisements

  2. You may need to set the voltage to at least 1.8 volts - I think at least
    some of those old boards don't support any lower voltage.
     
    Robert Hancock, Mar 25, 2005
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.