1. This forum section is a read-only archive which contains old newsgroup posts. If you wish to post a query, please do so in one of our main forum sections (here). This way you will get a faster, better response from the members on Motherboard Point.

ASUS PS2B-S Jumper Settings For 800mhz

Discussion in 'Hardware' started by Avery, Dec 2, 2003.

  1. Avery

    Avery Guest

    Does anyone know what the jumpers settings are for using a
    Slot 1 800mhz processor on a ASUS PS2B-S v 1.04 ?

    I have checked a few sites and cannot figure out the jumper setting.

    Thanks in advance.

    Avery
     
    Avery, Dec 2, 2003
    #1
    1. Advertisements

  2. Avery

    Ron Cook Guest

    -----BEGIN PGP SIGNED MESSAGE-----
    Hash: SHA1
    First: PLEASE make sure that you have the model number of the motherboard
    correct. Asus had no product under the model "PS2B-S", but they did have a
    "P2BS".

    The Asus site at:
    < http://www.asus.com.tw/support/download
    item.aspx?ModelName=P2B-S&Type=Latest >

    has the manual.

    (The link above may be split over two or more lines due to its length.)

    According to the manual (and I presume based on the original BIOS) these
    jumpers will give you a 100 MHz bus speed and a 6.0x multiplier:

    BF0, BF1, BF2 are set to pins 2 & 3
    BF3 is set to pins 1 & 2
    FS0, FS1, FS2 are set to pins 1 & 2

    Also note that according to this site you'll need to have version 1013.004
    of the BIOS.

    I'd suggest downloading the manual, reading it, and checking your board
    against its suggestions.

    - --
    Ron n1zhi

    -----BEGIN PGP SIGNATURE-----
    Version: GnuPG v1.2.2 (GNU/Linux)

    iD8DBQE/zRK7a9fyRcf4bIYRAj2xAJwLu15tBDBwALmiL06i03lpFZPgqACfUhQs
    Ha7RBUQlCHX7psB+XssO0vo=
    =f7lq
    -----END PGP SIGNATURE-----
     
    Ron Cook, Dec 2, 2003
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.