ATI 8500DV and SiI RAID controller conflict

Discussion in 'Soyo' started by Jim, Oct 9, 2003.

  1. Jim

    Jim Guest

    I just installed WinXP on my SY-P4I875P Dragon 2 Platinum, booting from 2
    SATA Seagate 80G drives on the SiI 3112 controller with the RAID settings on
    'stripe'. The video card during installation was a generic NVidea RIVA TNT2
    64, and it booted up and ran just fine. I am trying to install an ATI AIW
    8500DV /64 M, and the system recognizes the SiI drives, but not the RAID
    setup, and says it can't locate the operating system. The same hardware set
    up will boot and load from the XP, so I assume the problems is a conflict
    with the RAID controller. Is there a solution to this problem, or do I have
    to re-install the operating system on an IDE drive to be able to boot up and
    use this video card?

    Thanks

    Jim
     
    Jim, Oct 9, 2003
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.