Biostar M7VIT Pro problems

Discussion in 'Biostar' started by John Voznak, Nov 5, 2003.

  1. John Voznak

    John Voznak Guest

    I installed the new board (Athlon 2600+ 333 and 256 megs PC2700) and ran
    into troubles while installing the new OS on the new WD hard drive. It
    gets to the point where it says "Starting Windows" and then it either
    freezes up or I get one of numerous error messages, like a page fault
    error, etc. I also tried formatting the HD and installing Windows 98SE,
    but it usually just reboots at some point during the install. I also
    tried moving the ram to a different slot and I went and bought a new
    stick of ram and tried that too, no good....

    Anybody have any ideas????

    John
     
    John Voznak, Nov 5, 2003
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.