1. This forum section is a read-only archive which contains old newsgroup posts. If you wish to post a query, please do so in one of our main forum sections (here). This way you will get a faster, better response from the members on Motherboard Point.

Boot up problems after adding new hardware

Discussion in 'PC Hardware' started by Slaphead, Oct 17, 2003.

  1. Slaphead

    Slaphead Guest

    I have been running my Windows 98SE system for quite a few years with no
    problems. I have installed the software for my new 54 Mbps wireless PCI
    Adapter network cardand installed the hardware. My PC won't boot up. It
    doesn't even get to booting the operating system or sending any signal to my
    monitor. If I remove the card and switch on the moitor springs into life and
    the system boots into windows. Every time I switch on with the card
    installed no signal goes to the monitor and the hard disk stops whirring
    after a few sconds and does not boot into windows. Any idea what the problem
    could be?
     
    Slaphead, Oct 17, 2003
    #1
    1. Advertisements

  2. I have been running my Windows 98SE system for quite a few years with no
    Sounds to be 'broken'. Do you have another system you could test it on?
    Send/take it back to supplier!

    Mike.
     
    Michael Hawes, Oct 17, 2003
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.