cpu temp?

[---==T.F==---]

Hi! I need some advice here!!!

i got this setup:
ic7-g card with Intel 3.0 800Mhz HT and an Abit IC7-G with corsair XMS 3500 434 Mhz... Its a Boxed cpu with the Intel cooler... first there was no fans in my case no i got a fan but the temp is really high... Im into 3D rendering so i stress the cpu alot what can i do? buy another case? or should i be fine with a better fan for my cpu? please help !!!! Regards Tommy
Icq:61325022

 

[Devast8or]

---==T.F==--- wrote:

Hi! I need some advice here!!!

i got this setup:
ic7-g card with Intel 3.0 800Mhz HT and an Abit IC7-G with corsair XMS 3500 434 Mhz... Its a Boxed cpu with the Intel cooler... first there was no fans in my case no i got a fan but the temp is really high... Im into 3D rendering so i stress the cpu alot what can i do? buy another case? or should i be fine with a better fan for my cpu? please help !!!! Regards Tommy ...

A better heatsink and fan on the CPU might help (I don't know the cooling capabality of the box cooler), but you will probably need better airflow in your case too. Put two fans in the case, one in the front bottom to take cool air into the case, and one in back top to blow the hot air out. Make holes in the case if necessary. That should help.

What's your CPU temp now (idle and full load)? And your case temp? Is your computer stable as it is now? Is it overclocked?

Devast8or

 

[---==T.F==---]

well it from 48 and up to 70...
its not overclocked...
i just one fan in the case...
that in the back of the case ..should i try change the fan so i drag out the air instead? regards Tommy the heat-fool...

"---==T.F==---" skrev i meddelandet

Hi! I need some advice here!!!

i got this setup:
ic7-g card with Intel 3.0 800Mhz HT and an Abit IC7-G with corsair XMS 3500 434 Mhz... Its a Boxed cpu with the Intel cooler... first there was no fans in my case no i got a fan but the temp is really high... Im into 3D rendering so i stress the cpu alot what can i do? buy another case? or should i be fine with a better fan for my cpu? please help !!!! Regards Tommy ...

 

[Styvaen]

"---==T.F==---" wrote:

well it from 48 and up to 70...
its not
i just one fan in the case...
that in the back of the case ..should i try change the fan so i drag out the air instead?
regardsoverclocked...
Tommy the heat-fool...

The correct airflow for a tower case is air goes in at the front and bottom (hopefully also bathing your hard drive(s) with cool air). Then rising up through the case (warm air rises, right?). And extracted through the PSU fan at the rear and top of the case. If you have two intake fans then you should have two exhaust fans including the one in your power supply unit.

Make sure that unused rear fan ducts are not sucking in warm air from the PSU.

Styvaen.

 

[Devast8or]

---==T.F==--- wrote:

well it from 48 and up to 70...

Whoa, that's a lot. My XP2000+ only gets 51 on full load, and my airflow is not very good.

its not overclocked...
i just one fan in the case...

Get more fans.

that in the back of the case ..should i try change the fan so i drag out the air instead?

Yes, if it's in the top of the case it should pull out the hot air.

regards
Tommy the heat-fool...

Devast8or