ga-k8nf-9 and front audio connectors

Discussion in 'Gigabyte' started by Michael Taylor, Dec 22, 2005.

  1. I want to wire up the front audio connectors so that when I plug a front
    audio output and microphone cable, it cuts out the rear connectors.

    I also have a ga-k8nf-9-ultra with the same front audio connector. i'm using
    it an Acousticase C6607 system case which comes supplied with a header
    cable, and works a treat.

    I'd like to do the same using the k8nf-9 in a basic system case, but one
    where i've installed an Akasa front audio panel. I've got 3 pins as output
    from each of the two cables (speaker and microphone) but I'm not sure how to
    connect them to the front audio header. I've tried various combinations. I
    couldn't get the microphone to work at all, and the sound was very quiet.
    When the speaker out cable was removed it wouldn't revert to the rear audio
    out, which does happen on the ultra.

    Any ideas?

    Mike
     
    Michael Taylor, Dec 22, 2005
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.