HD light stays on for SD11

Discussion in 'FIC' started by J. P. Willis, May 5, 2006.

  1. J. P. Willis

    J. P. Willis Guest

    I have changed the drive cable but cannot get the drive lght to go off
    so that it will boot. The drive is fine on another computer when I
    place it there.

    Please advise me as to the problem. Thanks.
     
    J. P. Willis, May 5, 2006
    #1
    1. Advertisements

  2. J. P. Willis

    farmuse Guest

    the SD11 had issues with UDMA, either the ribbon cable is backwars,
    bad, or the connector on the motherboard is bad. If all else fails then
    use a controller card, like a Promise card. They are much better than
    what the SD11 can run a modern drive at.
     
    farmuse, May 9, 2006
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.