how to change the entry point for secondary boot loader?

Discussion in 'Motherboard General Discussion' started by Lucky443, Apr 9, 2009.

  1. Lucky443

    Lucky443

    Joined:
    Apr 9, 2009
    Messages:
    1
    Likes Received:
    0
    Hi All,
    I have a KMC board with mips VR4131 processor. The target board already having cmon boot loader on flash. Now I need to put my yamon boot loader (cmon boot loader has to be there as protected) which I modified according to the requirement on the flash. As we know MIPS have fixed starting address 0xbfc00000, how to change this address to other address so that after power on it can enter to the new address of the yamon bootloader
    If any one has some idea, please help me
    Thanks in advance.

    Regards,
    Lucky
     
    Lucky443, Apr 9, 2009
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. IDE primary SATA secondary

  2. The Enigma of the Asus A8n5x and the video that only displays when cmos is reset

  3. Compaq Secondary Controller Failure / DriveLock Multibay Password

  4. Toshiba Satellite backlight turns off when screen is opened past a certain point

  5. How to change POP (Power On Password)?

  6. x4270 , not able to change Boot Order in LSI utility

  7. ez430-rf2500 sending from access point to end device

  8. The ASUS M2N-E SLI motherboard does not even start on the motherboard LAN port, and the speaker port

Loading...