Machine won't boot after adding a disk

Discussion in 'Technical Support' started by revnice, May 5, 2020.

  1. revnice

    revnice

    Joined:
    May 5, 2020
    Messages:
    1
    Likes Received:
    0
    Machine is Asus Z390-E, i9-9900K chip with 32 RAM and an Intel M.2 SSD as the boot drive. The other disks are conventional (spinning) SATA drives with MBR partition scheme but none of them have an OS on them.

    There is nothing wrong with any of the disks and data is visible when they're attached to another computer. Disconnect the disks and it boots just fine.

    BIOS Settings
    Fast Boot is enabled
    Secure Boot is enabled
    CSM is enabled
    Boot Device Control > UEFI and Legacy OPROM
    SATA Controllers > Enabled
    SATA Mode > Intel RST RAID
    All SATAs are Enabled, All Hotplugs are Disabled

    Thanks for any suggestions - rev
     
    revnice, May 5, 2020
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Need boot disk for NEC Ready 9714

  2. PC Won't Boot w/o Recovery Disk

  3. Upgrading my machine.. memory question

  4. Inspiron 530 Desktop - anyone have experience of this machine ?

  5. d915gev won't boot after memory upgrade

  6. STUMPED! HP G72 Won't Boot After CPU, Motherboard, and RAM Upgrades - Caps Lock Single Blink

  7. Gateway E-4000 machine parts

  8. Machine won't boot after power failure

Loading...