MX4GVR - P4 2.8Ghz Northwood - unable to modify clock ratio - help

Discussion in 'AOpen' started by jim, Jun 7, 2004.

  1. jim

    jim Guest

    I have an MX4GVR board
    BIOS 1.14
    Intel Northwood P4 2.8 Ghz chip
    The clock ratio is set in the BIOS at 14
    It seems like I cannot change it so the chip is running at only 1.8 Ghz

    Anyone out there have any ideas, suggestions, solutions ?

    Many Thanks

    jim, Jun 7, 2004
    1. Advertisements

  2. jim

    BMartin Guest

    14 is the correct multiplier for a 2.8
    12 for 2.4
    15 for 3.0
    BMartin, Jun 8, 2004
    1. Advertisements

  3. jim

    *jimanno Guest

    Have you checked the bus speed frequency? It seems yours is set to 133
    MHz, which would get approx. 1.8 GHz. It should be set to 200 MHz
    (x14=2800 MHz, or 2.8 GHz.)


    remove* *for email
    *jimanno, Jun 8, 2004
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.