NF7-S Mic Bias

Discussion in 'Abit' started by Jon, May 18, 2004.

  1. Jon

    Jon Guest

    Just installed an NF7-S into a new case, and all is running fine. However,
    I'm at a loss about one of the wires that connects to my front panel
    microphone jack. The mic jack works fine, but I have one wire left over --
    don't know where it goes. It's labeled 'Mic Bias'. Does anyone have a clue
    what pin that needs to go on, and on what header? I'm just running a pair
    of regular desktop speakers; nothing fancy. There's nothing in the manual
    as far as I can tell. Thanks in advance for your help.
    Jon
     
    Jon, May 18, 2004
    #1
    1. Advertisements

  2. Jon

    Robert Guest

    Robert, May 18, 2004
    #2
    1. Advertisements

  3. Jon

    Jon Guest

    Thank you very much, esp. for the second reference.
    Jon
     
    Jon, May 18, 2004
    #3
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.