1. This forum section is a read-only archive which contains old newsgroup posts. If you wish to post a query, please do so in one of our main forum sections (here). This way you will get a faster, better response from the members on Motherboard Point.

PIC P18F4550 USART Receive Problem

Discussion in 'Embedded' started by gary.ireland, Jun 25, 2007.

  1. gary.ireland

    gary.ireland Guest


    I'm using the Microchip PICDEM board to test USART on the 4550 PIC.
    I'm using the default settings and the test code to tx/rx data via
    USART. I can Tx data but Rx doesn't work at all. I've tried all
    routes to get it working - any ideas? Is there any pins I need to set
    up although I've already tested with: RISCbits.TRISC7=1; and
    TRISCbits.TRISC6=0; but still not working on Rx. All Baud rate
    settings, SPBRG/H etc are set up and seem fine... What am i missing to
    get Rx working?????

    Greatly Appreciated!

    gary.ireland, Jun 25, 2007
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.