Problem with Shuttle SN45G and Athlon XP 2800

Discussion in 'Shuttle' started by Rawhide Kid, Jul 10, 2003.

  1. Rawhide Kid

    Rawhide Kid Guest

    I recently purchased a Shuttle SN45G and installed my Athlon XP 2800.
    It is only recognized as a 1250Mhz Athlon. When I go into the BIOS to
    change the FSB setting to 166Mhz and the multiplier to 12.5, the
    system locks after I save and exit. I have to clear the CMOS to get it
    to reboot. Any changes I make in the Bios seem to cause a lock-up. I
    already downloaded and installed the lates Bios revision, "I". Any
    help would be greatly appreciated.
     
    Rawhide Kid, Jul 10, 2003
    #1

    1. Advertisements

  2. Rawhide Kid

    eric Guest

    try decreasing your ram timings and speed down to 100mhz @ 8-3-3-3 or
    something just to check if its your ram.
     
    eric, Jul 11, 2003
    #2

    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Semperon 2800 with Athlon XP 2800 heatsink.

  2. winxp setup cant find hard drive on shuttle SN45G

  3. Building a Shuttle SN45G/Athlon Based System

  4. Shuttle XPC SN45G a few ?'s

  5. SHUTTLE SN45G V3.0. Unreliable

  6. Shuttle SN45G + ATI 9600 Pro?

  7. Shuttle SN45g and which video card?

  8. athlon pro 2800+ vs athlon xp 2800+

Loading...