1. This forum section is a read-only archive which contains old newsgroup posts. If you wish to post a query, please do so in one of our main forum sections (here). This way you will get a faster, better response from the members on Motherboard Point.

SE 3510

Discussion in 'Sun Hardware' started by M Han, Sep 23, 2003.

  1. M Han

    M Han Guest

    I need to set uo a SE3510 JBOD FC array connecting to
    two Sun servers, in order to have a HA system - sharing
    an array between two servers. I notice that there are 4 ports
    on the back of the array.
    So, I assume that one server connection goes
    to the upper left port and the other's goes to the lower right port.

    But, SE3510 Document says Sun doesn't support this configuration.
    Is it possible to setup this way?
    Any customization/modification is required?
    I appreciate any comments and suggestions.

    Thanks, M Han
     
    M Han, Sep 23, 2003
    #1
    1. Advertisements

  2. I think you should use the Raid controller with its cache memory and raid-5
    to get better performance and availability.
    Becuase then you have more than one initiator on each FC_AL loop?


    /wfr
    Fredrik
     
    Fredrik Lundholm, Sep 23, 2003
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.