SJ1 Jumper at ECS KV2 mainboard (power led)

Discussion in 'ECS' started by M.A.Rauder, May 16, 2007.

  1. M.A.Rauder

    M.A.Rauder Guest

    @my question about the front panel pin connector
    power led and the Jumper SJ1 on the ECS KV2:

    "ECS Support Posted : GMT 2007/05/14 09:26:55

    Dear Customer,

    SJ1 pin is made for old ATX cases which use three pins connector power LED.

    You can use one of those two connectors as well as both gives 5V signal.

    Thanks & regards,
    Elitegroup Computer Systems EU B.V.
    Technical Support Department"
     
    M.A.Rauder, May 16, 2007
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.