1. This forum section is a read-only archive which contains old newsgroup posts. If you wish to post a query, please do so in one of our main forum sections (here). This way you will get a faster, better response from the members on Motherboard Point.

Start-up code for x86 (Pentium) targets on GHS

Discussion in 'Embedded' started by Ignacio Gonz?lez T., Jul 1, 2004.

  1. I'm trying to set up a proprietary Pentium-based prototype with The
    Green Hills MULTI tools. Alas, the default start-up code that comes
    with them is taylored to a PC-based with BIOS, diskette and the like,
    already in 32-bit protected mode, which is not my case.

    Before playing with Intel's psycho-chip, and guessing when I need an
    override prefix and where, I wonder if somebody could lend me a hand
    and providing me with some start-up code for a bare board like mine.

    Thanks a lot.
     
    Ignacio Gonz?lez T., Jul 1, 2004
    #1
    1. Advertisements

  2. Ignacio Gonz?lez T.

    Jim Stewart Guest

    Sounds like lots of head-banging in your future :)

    Take a look at the linux bios project. The initialization
    code might help you:

    http://www.linuxbios.org/
     
    Jim Stewart, Jul 1, 2004
    #2
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.