Supermicro X9DBL-3F very slow booting with GTX-1060 card installed

Discussion in 'Motherboard General Discussion' started by Frank Tarczynski, Jun 20, 2018.

  1. Frank Tarczynski

    Frank Tarczynski

    Joined:
    Jun 20, 2018
    Messages:
    1
    Likes Received:
    0
    I updated the video card in a Supermicro X9DBL-3F system from an Asus GTX-760 to an EVGA GTX-1060. When the system boots, the POST hangs at the first BIOS banner page for ~40 seconds before then continuing on and booting-up just fine.

    Booting was quick with the old video card, but now hangs with the new card. This is all during the POST so it's not a drive issue.

    I've tried pulling the power cord and battery and resetting the CMOS on the board and loading the BIOS defaults but no improvement.

    Anyone have any ideas?

    Frank
     
    Frank Tarczynski, Jun 20, 2018
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Very slow start

  2. Dell Inspiron very slow

  3. fans inside are very noisy with new motherboard

  4. three screen setup with the gtx 650

  5. supermicro X9DRi-LN4F+ not booting

  6. Supermicro P3TDDE : 4GB memory installed, but only see 3.6GB on POST

  7. Asus Maximus xii hero with GTX 1060

  8. Supermicro C7Q270-CB-ML Keeps booting into BIOS

Loading...