Thunder S2518 LE-T POST problem

Discussion in 'Tyan' started by Matt, May 26, 2004.

  1. Matt

    Matt Guest

    Hi all,

    My S2518 LE-T motherboard will not POST at all. I am using a P3 733Mhz
    (256K, 133Mhz) processor, and (2) Apacer PC133 128Mb ECC modules (installed
    in the #1 & 2 slots from the middle of the board. The processor is installed
    in the #1 CPU socket. I power it up, and I don't even get the first beep. I
    checked the jumpers (according to the manual), and they are all set
    correctly. I reset the CMOS. Any suggestions? Thanks ahead of time.
     
    Matt, May 26, 2004
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.