FT2232D Using a SPI mode

Discussion in 'Technical Support' started by leonardo.vieira, Nov 9, 2010.

  1. leonardo.vieira

    leonardo.vieira

    Joined:
    Nov 9, 2010
    Messages:
    1
    Likes Received:
    0
    Location:
    Brazil
    Hi guys, it's my first time using the forum so if do anything wrong please give a tip.

    I'm working on a project which purpose is to connect a DSP(microcontroller) to a PC.
    To do this interface I'm using a FT2232D from FTDI.

    I will use a SPI transmission using Labview as a aplication program.

    FTDI support the SPI example for Labview and so far it's okay. But FTDI provides us with two DLL's .The D2XXX dll and the FTCSPI DLL.

    For my purpose which I should I use? Or will I have to use them both?
    Which should de easier?

    Thanks
     
    leonardo.vieira, Nov 9, 2010
    #1
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.